01
Compact footprint
An innovative compact design with a minimal footprint delivers 3 to 25 GPM of lube oil to serve power generators in tight CHP spaces.
Choose your flow class
Sized to the tank in front of you.
Select a model to see where it fits in the family. Every class shares the same filtration, controls, and enclosure — only the flow rate changes.
LM1
3–25 GPM (12–100 LPM)
The LM1 Simplex Lube Oil Pump is used to Transfer Lube Oil to and from Power Generators. The pump may be located at the lube tank to deliver fresh oil to the engine, or at the engine to remove and transfer waste oil.
Motor
TEFC, 0.5 to 1.5 HP (0.33 - 1.1 KW)
Power
120-230 VAC, 1 Phase, 50-60 HZ
Flow range
Family span · 0–300 GPM
0
75
150
225
300 GPM
The engineering
Built for reliable lube transfer.
02
Viking positive-displacement pump
The mechanical design is based on proven Viking PD pumps, complete with strainers, check valves, ball valves, gauges, and relief valves.
03
Integration-ready controls
The C11 controller provides pump operation and monitoring with HOA switches and an emergency stop, ready for CAT, Cummins, MTU, and Kohler systems.
04
Containment & leak detection
The unit is mounted on an integral containment basin with leak-detection and flow monitoring, and current sensors for performance feedback.
Model Detail
Model
Flow
Motor
Power
LM1
3–25 GPM (12–100 LPM)
TEFC, 0.5 to 1.5 HP (0.33 - 1.1 KW)
120-230 VAC, 1 Phase, 50-60 HZ
Built for lube transfer
Sited where the oil needs to move.
Deliver fresh oil
Located at the lube tank, the LM1 delivers fresh oil to the generator engine on demand.
Remove waste oil
Located at the engine, the same pump removes and transfers waste oil out for disposal or recycling.
Reliable at CHP scale
Designed for high-reliability lube transfer in generator power systems at combined heat & power facilities.
Integration ready
Direct integration into CAT, Cummins, MTU, Kohler, and other generator control and monitoring systems.
Equipment & options
Configured for your install.
Every LM1 ships as a complete simplex pump set — valves, strainer, gauges, containment, and sensors on an integral skid — and adapts to the flow rate, enclosure finish, and generator control system of the site.
Standard equipment
Inlet & outlet ball valves
Inlet Y-strainer
Outlet check valve
Inlet compound gauge (‒30 to +130)
Outlet pressure gauge (0–100 PSI)
Integral containment basin
Leak sensor & flow sensor
C11 controller with HOA switches & E-stop
Options
Stainless steel enclosure (vs. powder-coat RAL 7035)
Motor starter panel with disconnect switch
Current sensors for performance feedback
Floor-mount stand, 24 in (600 mm)
Integration for CAT / Cummins / MTU / Kohler
Relief valves & pressure regulation
Product Specifications
See what it's built to do.
Model
Flow
Motor
Power
LM1
3–25 GPM (12–100 LPM)
TEFC, 0.5 to 1.5 HP (0.33 - 1.1 KW)
120-230 VAC, 1 Phase, 50-60 HZ
All models filter water + particulate to 1 micron · ISO 18/16/13 · NEMA 4 (IP65) · C81 controller, BACnet / Modbus