The M300 Filtration / Polisher is designed to circulate and clean fuel stored diesel fuel at critical facilities. Filtration / Polishing has become an important aspect of emergency power reliability: * critical facilities store increasing amounts of fuel onsite to assure continuity of operation and this fuel has low turnover in operation.

• as diesel fuel ages, particulates form which can increase the wear on generator engine parts
• fuel storage tanks accumulate water through vapor condensation and this water can encourage bacterial growth
• newer diesel engines with improved emissions technology require higher purity fuel to prolong engine life.

The M300 Filtration / Polisher has an innovative compact design has a minimal footprint for Filtration / Polishing of tanks from 500 to 50,000 gallon capacity

The mechanical design is based on Viking pumps and Racor filters and is complete with strainers, check valves, ball, valves, pressure / vacuum gauges, relief valves. The unit is mounted on an integral containment with leak detection monitoring.

The Filtration / Polisher includes a motor starter panel, or optional VFD drive, with disconnect switch. The OmniPlex Controller provides Filtration / Polisher operation and monitoring with HOA switches and an emergency stop.

Resources:

M300 Filtration Polisher Data Sheet “PDF”
M300 Filtration Polisher Instruction Manual “PDF”
M300 Filtration Polisher Short Specification “Word DOC”

M300.B01 Filtration Operating Modes “PDF”
M300.B02 Filtration Electronic Monitoring “PDF”
M300.B03 Filtration Flow – Meter Functions “PDF”

M300.T01 Diesel Fuel Quality “PDF”
M300.T02 Biocide Recommendations “PDF”